Electronics Line Penta XL series Instalační manuál stáhnout pdf (Strana 23)

-23-

Address 74: Primary Communication Protocol

Address 75: Duplicate Communication Protocol

Address 76: Backup Communication Protocol

Telephone numbers

Address 77: Primary Telephone Number

The Primary 1 telephone number is the first number that is dialed when an event occurs.

You can enter a maximum of 16 digits at this address. To add a two-second pause, enter

B (

4, 1). To switch from pulse to DTMF dialing enter E (4, 4). To add a “4", enter (4, 4).

To add a “#”, enter (

4, #). These additional digits are included in the 16 digit total. Press

ENTER after you program the last digit of the telephone number.

Address 78: Duplicate Telephone Number

The Duplicate telephone number enables the control panel to report events to more than

one central station. The Duplicate telephone number is programmed in the same way as

the Primary telephone number (address 77).

Address 79: Backup Telephone Number

If the panel fails to communicate with either the Primary or Duplicate numbers within a

communication round, the Backup telephone number is dialed. The Backup telephone

number is programmed in the same way as the Primary telephone number (address 77).

Address 80: RP Callback Telephone Number

Remote programming communication can be established using two methods, passcode

and callback (see address 02, second digit). If RP callback is selected the panel receives

a call from the remote programmer, hangs up and calls back using the telephone number

programmed at this address. The RP callback telephone number is programmed in the

same way as the Primary telephone number (address 77).

Note: To disable a telephone number, enter the appropriate address and press ENTER. It is

not possible to program a backup number unless a primary number has been programmed.

Address 81: RP Access Code

This 4-digit code grants access to the remote programmer.

Note: Do not enter Hex digits.

Address 82: Account Number

When an event code is sent, the central station receives an account number to identify

the customer. Enter a 4-digit account number at this address.

Address 83: Installer Code

The installer code is a 4-digit code which grants access to programming mode. The

default for this code (1234) should be changed immediately after installing the system.

Note: Do not enter Hex digits.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 32 33

Žádné komentáře

Electronics Line Penta XL series Instalační manuál Strana 23