Electronics Line 3208GLD Uživatelský manuál stáhnout pdf (Strana 13)

CHAPTER THREE: SYSTEM OPERATION FOR THE 3106 LED AND 3108 LCD KEYPADS

3.1: General

The Summit 3208GLD can be operated by using either the 3108 LCD or 3106 LED keypads. All the parameters

can be programmed using either the LCD keypad or the Remote Programmer software. Refer to Chapter Four:

Programming, page 23, for instructions relating to programming the system.

3.2: Display and Controls

Keypad Layout

LED Display

1 - 8: Used to display zone status and system status.

READY: Indicates if the system is ready to perform functions.

PROGRAM: Indicates if the system is in programming mode. The Program LED lights up if SELECT is pressed

and blinks to indicate that the system is waiting for an authorized user code to be entered.

BYPASS: Indicates if zones have been bypassed. The Bypass LED and the relevant zone LEDs blink to

indicate that zones have been bypassed.

TROUBLE: Blinks if a trouble situation exists within the system (telephone communication failure).

Status Indicators

ARMED: On when the system is armed, off when the system is disarmed.

Note: If the keypad is programmed to display all systems, the Armed LED lights up only when all

systems are armed.

POWER: On when both the AC and the backup battery are connected, provided that the voltage supplied by

the battery is over 10.8V and AC power supply is between 50 - 60 Hz. The indicator blinks slowly when the

battery is low and turns off to indicate AC power loss.

System Trouble Chimes

The keypad indicates certain trouble situations, such as AC loss and low battery by chiming. Pressing any

key on the keypad terminates these chimes.

LED

Display

Buzzer

Arming

Keys

Numeric

Keypad

LCD

Display

Status

Indicators

Select

Key

LED Keypad

LCD Keypad

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 50 51

Žádné komentáře

Electronics Line 3208GLD Uživatelský manuál Strana 13